| 1,922 | 56 | 84 |
| 下载次数 | 被引频次 | 阅读次数 |
结合烧失量与单轴拉、压实验,研究了空气及热水(1 d,60℃热水+2 d空气)养护条件下混杂钢纤维超高性能混凝土(UHPC)试件的3 d龄期水化程度与力学性能,同时利用数字图像相关技术与光学显微镜对拉伸试件表面的开裂特性进行了表征,并通过扫描电子显微镜对其微观结构进行了分析。结果表明:与空气养护相比,热水养护加快了UHPC基体的水化反应进程,温度的升高是促进水化反应的主要因素;热水养护UHPC试件的初裂、抗拉及抗压强度明显提高,但其拉伸应变性能的变化并不明显;试件的最大裂缝宽度总体上有所降低;基体变得更加致密,纤维与基体的界面粘结也更强。随着纤维掺量的增加,UHPC的拉伸应变有所提高,总体积掺量为2.5%(长、短纤维比例分别为1.25:1.25,1.5:1.0)试件的拉伸应变均超过了2×10-3;混掺1.5%(体积分数)长纤维与1.0%短纤维试件在热水养护下产生了较多宽度小于50μm的微裂缝。DIC技术获得的理论应变与单轴拉伸实测应变之间具有较好的吻合度。
Abstract：The hydration degree and mechanical properties of ultra-high performance concrete(UHPC) specimens with hybrid steel fibers cured in air and hot water(1 d, 60℃ hot water+2 d air), respectively, were investigated via ignition loss tests and uniaxial tensile and compressive tests. Also, the surface cracking characteristics of tensile specimens were characterized by digital image correlation technique and optical microscopy, and the microstructures were analyzed by scanning electron microscopy. The results show that compared with the results obtained in air curing, hot water curing accelerates the hydration reaction progress of the UHPC matrix, and an increase in temperature mainly contributes to the promotion of hydration reaction, thus improving the initial cracking,tensile and compressive strength of the UHPC specimens in hot water curing. However, the tensile strain capacity changes slightly. In general, the maximum crack width of the specimen decreases, the matrix becomes denser, and the interface bonding between the fibers and the matrix is stronger. The tensile strain of UHPC increases with the increase of fiber content, in which the tensile strains of the specimens with 2.5%(volume fraction) of fibers(a ratio of long fibers to short fibers is 1.25: 1.25 and 1.5: 1.0, respectively) are more than 2 ×10-3, the specimen with 1.5% long fibers and 1.0% short fibers produces more tensile cracks with the width of < 50 μm in hot water curing. The uniaxial tensile strains predicted by DIC are in reasonable agreement with the strains measured.
[1] SHEN P L, LU L N, HE Y J, et al. The effect of curing regimes on the mechanical properties, nano-mechanical properties and microstructure of ultra-high performance concrete[J]. Cem Concr Res, 2019, 118:1–13.
[2] WANG Z, WANG J Q, ZHU J Z, et al. Energy dissipation and self–centering capacities of posttensioning precast segmental ultra-high performance concrete bridge columns[J]. Struct Concr, 2020, 2(21):517–532.
[3] YU R, SPIESZ P, BROUWERS H J H. Mix design and properties assessment of ultra-high performance fibre reinforced concrete(UHPFRC)[J]. Cem Concr Res, 2014, 56:29–39.
[4] HEINZ D, URBONAS L, GERLICHER T. Effect of heat treatment method on the properties of UHPC, Proceedings of Hipermat 2012 3rd International Symposium on UHPC and Nanotechnology for High Performance Construction Materials, 2012:283–290.
[5] YAZICI H, DENIZ E, BARADAN B. The effect of autoclave pressure,temperature and duration time on mechanical properties of reactive powder concrete[J]. Constr Build Mater, 2013, 42:53–63.
[6] MASSIDDA L, SANNA U, COCCO E, et al. High pressure steam curing of reactive-powder mortars[J]. ACI, 2001, 200:447–464.
[7] WU Z M, SHI C J, HE W. Comparative study on flexural properties of ultra-high performance concrete with supplementary cementitious materials under different curing regimes[J]. Constr Build Mater, 2017136:307–313.
[8]詹国良,林东,沈云泽,等.养护制度对活性粉末混凝土强度影响机理研究[J].建筑科学, 2016, 32(5):96-100.ZHAN Guoliang, LIN Dong, SHEN Yunze et al. Build Sci(in Chinese),2016, 32(5):96-100.
[9]吴炎海,何雁斌,杨幼华,等.养护制度对活性粉末混凝土(RPC)强度的影响[J].福州大学学报, 2003, 31(5):593-597.WU Yanhai, HE Yanbin, YANG Youhua et al. J Fuzhou Univ:Nat Sci Ed(in Chinese), 2003, 31(5):593-597.
[10]高小建,李双欣.微波养护对掺矿渣超高性能混凝土力学性能的影响及机理[J].材料导报, 2019, 33(1):271–276.GAO Xiaojian, LI Shuangxin. Mater Rev(in Chinese), 2019, 33(1):271–276.
[11]安明喆,刘亚州,张戈,等.再水化作用对超高性能混凝土基体显微结构和水稳定性的影响[J].硅酸盐学报, 2020, 48(11):1722-1731.AN Mingzhe, LIU Yazhou, ZHANG Ge, et al. J Chin Ceram Soc, 2020,48(11):1722-1731.
[12] KAN L L, SHI H S, SAKULICH A R, et al. Self-healing characterization of engineered cementitious composite materials[J].ACI Mater J, 2010, 107(6):617–624.
[13] ZHANG Y M, SUN W, YAN H D, Hydration of high-volume fly ash cement pastes[J]. Cem Concr Compos, 2000, 22(6):445–452.
[14] ZHANG J, YAN C W, BAI P C, WANG X X, LIU S G, LIU Z G.Effects of calcium silicate slag on hydration of cementitious pastes[J].Materials, 2019, 12:3094.
[15] AN M Z, WANG Y, YU Z R. Damage mechanisms of ultra-high-performance concrete under freeze–thaw cycling in salt solution considering the effect of rehydration[J]. Constr Build Mater,2019, 198:546–552.
[16]阚黎黎,庞成凯,王飞,等.聚乙烯纤维增强高延性碱矿渣复合材料的拉压性能及裂缝分布[J].复合材料学报, 2021, 38(12):4309-4316.KAN Lili, PANG Chengkai, WANG Fei, et al. Act Mater Compos Sin(in Chinese), 2021, 38(12):4309-4316.
[17] ZHAO P, ZSAKI A M, NOKKEN M R, Using digital image correlation to evaluate plastic shrinkage cracking in cement-based materials[J]. Constr Build Mater, 2018, 182:108–117.
[18]蒋睿.早期养护方式对超高性能混凝土性能的影响[J].硅酸盐学报,2020, 48(10):1659-1668.JIANG Rui. J Chin Ceram Soc, 2020, 48(10):1659-1668.
[19] YANG E H, WANG S X, YANG Y Z, et al. Fiber-bridging constitutive law of engineered cementitious composites[J]. J Adv Concr Technol, 2008, 6(1):181–193.
[20] MCS-EPFL Lausanne, Recommendation:Ultra-High Performance Fibre Reinforced Cement-based composites(UHPFRC)Construction material, dimensioning und application, Zurich, Switzerland, 2016.
[21]苟鸿翔,朱洪波,周海云,等.定向分布钢纤维对超高性能混凝土的增强作用[J].硅酸盐学报, 2020, 48(10):1757-1765.GOU Hongxiang, ZHU Hongbo, ZHOU Haiyun, et al. J Chin Ceram Soc, 2020, 31(12):1757-1765.
[22] LI V C, LEUNG C K Y. Steady-state and multiple cracking of short random fiber composites[J]. J Eng Mech, 1992, 118:2246-2264.
[23]刘建忠,韩方玉,周华新,等.超高性能混凝土拉伸力学行为的研究进展[J].材料导报, 2017, 31(12):24-32.LIU Jianzhong, HAN Fangyu, ZHOU Huaxin, et al. Mater Rev(in Chinese), 2017, 31(12):24-32.
[24] KANDA T, LI V C. Practical design criteria for saturated pseudo strain hardening behavior in ECC[J]. J Adv Concr Technol, 2006,(4):59–72.
[25]高峰,郝贠洪,吴安利,等.低模量聚酯纤维/水泥基复合材料抗冲击性能及损伤机制[J].复合材料学报, 2021, 38(11):3838-3849.GAO Feng, HAO Yuanhong, WU Anli, et al. Act Mater Compos Sin(in Chinese), 2021, 38(11):3838-3849.
[26] LI V C. Tailoring ECC for special attributes:A review[J]. Inter J Concr Struct Mater, 2012,(6):135–144.
[27] ZHANG H R, JI T, LIN X Y. Pullout behavior of steel fibers with different shapes from ultra-high performance concrete(UHPC)prepared with granite powder under different curing conditions[J].Constr Build Mater, 2019, 211:688–702.
基本信息:
DOI：10.14062/j.issn.0454-5648.20210342
中图分类号:TU528.572
引用信息:
[1]阚黎黎,王飞,邬海江,等.不同养护条件下混杂钢纤维超高性能混凝土的早龄期力学性能及开裂特性[J].硅酸盐学报,2022,50(02):429-437.DOI:10.14062/j.issn.0454-5648.20210342.
基金信息:
国家自然科学基金项目(51508329)
2022-01-20
2022-01-20
2022-01-20